Supreme Duct Cleaning

Duct Cleaning Process

We began by laying down drop cloths and putting on shoe coverings or remove our shoes to protect your home. We cut access holes in your supply and return air ductwork which enables us to attach the large vacuum hose to create a negative pressure on your duct system.  We also drill 1″ holes in various locations of your supply and return system to allow us to insert out air brush device to clean your system. We install magnetic sheets over each register to create a high vacuum to the each opening as we work through the home, cleaning each register and vacuuming out the supply boot. Using a special 175 PSI “air scrub device” we push the dust down each supply into the main ductwork. In your basement we use the same high pressure air brush to push the dust and debris toward the furnace where the high volume vacuum unit is capturing everything through a series of five filters. We then repeat the process for your whole cold air system, cleaning the registers, register boots, and cold air ductwork. We then move to your furnace and “air scrub” the complete blower assembly, cold air/filter assembly,  and A-coil which removes any remaining dust or debris. Once all the dust is removed we use a patented device to fog your entire duct system with essential oils which helps eliminate odors, pet dander, and bacteria. We then install a metal patches to the access openings we created in your ductwork and plug all the holes in your supply runs or ductwork which we used for access for our air brush. We vacuum out all the area around the furnace and remove our equipment and make sure all the registers are back in place.